Tosot TM09HEDI Manual do Utilizador

7MaintenanceBefore inspection and maintenance of the unit. PLEASE set power switch to “OFF” to cut off thepower supply.3.1 Units3.2 FiltersCAUTION● In

84. Clean or replace each filter.6. Wash the air filters with water or clean them with vacuum cleaner.1. Vacuum dusts, and soak in warm water or wa

91. Operate the “FAN only” for several hours on a fine day to dry out the inside.2. After operation stops, turn off the breaker for the room air condi

10Operating guideOPERATION INSTRUCTIONS Working principle and special functions for coolingWorking principle and special functions for heatingDef

11Operating guideOPERATION INSTRUCTIONS

12OPERATION INSTRUCTIONSPrecautions5

13OPERATION INSTRUCTIONSCAUSESPROBLEMChecking before contact the service man6

INSTALLATION INSTRUCTIONSThe appliance shall not be installed in the laundry.Installation of indoor unit●●●●Such a place where cool air can be distrib

Refrigerant piping1)Drill a hole ( 55mm in diameter ) in the spot indicated by the symbol in the illustration as below .2)The location of the hol

Drain piping1)Use commercial regid polyvinyl chloride pipe general VP 20 pipe, outer diameter 26mm, inner diameter 20mmfor the drain pipe.2)The drain

TM09HEDITM12HEDITM18HEDI

Open the front panel, remove the 4 screws and dis-mount the front grille while pulling it forward.Follow the procedure below when removing the slitpor

The mounting plate should be installed on a wall which can support the weight of the indoor unit.1) Temporarily secure the mounting plate to the wall,

Connecting the refrigerant pipeWrenchIndoor unit tubingOpen-end wrench (fixed)Connection pipeFlare nut1)Use torque wrenches when tightening the flare

20Checking for gas leakage1)Check for leakage of gas after air purging2)See the sections on air purges and gas leak checks inthe installation manual f

Live the sensor securing plate, remove the front metal plate cover, and connect the branch wiring to the terminal block.1)Strip wire ends (15mm)2)Mach

Routine check after installationINSTALLATION INSTRUCTIONS22Check after installationItems to be checked Possible malfunction SituationHas it been fixe

INSTALLATION INSTRUCTIONS239Configuration of connection pipe and additional volume of refrigerant1. Standard length of connection pipe5m、7.5m、8m2. Mi

INSTALLATION INSTRUCTIONS24Configuration of connection pipe and additional volume of refrigerantSheet 2. Additional refrigerant charging amount for R

66129924612

ContentsOPERATION INSTRUCTIONS1. Part names and their functions ...

1Part names and their functionsINDOOR UNITCAUTIONOPERATION INSTRUCTIONS25℃25℃① If the supply cord is damaged, it must be replaced by the manufacturer

2Remote Controller DescriptionO P E R ATIO N IN S TR U C TIO N SHow to use the remote control to operate the unitIntroduction for icons on display scr

6Press this button to set up &down swing angle, which circularly changes as below:OFFThis remote controller is universal . If any command ,

Press this button, could select displaying the indoor setting temperature or indoor ambienttemperature.When the indoor unit firstly power on it will d

T-ON T-OFF:present time.Holding down either button above 2 seconds increases or decreases theCLOCK :time by 1 minute every 0.5 second and then by 10 m

6How to use the remote control to operate the unitOPERATION INSTRUCTIONS ★●●●●●1.Remove the battery cover plate from the rear of the remote controlle